Micromod MOD: 30ML Display Script Guide Bedienungsanleitung PDF herunterladen (Seite 31)

MOD 30ML Display Guide

Display Basics

2 -25

Action Comment

19. Select the Formats tab, and select the

Add button

The Specify Format Data dialog box

appears

20. In the Name field, type: TotLine Type over the default entry FMT1

21. In the Format Type field, use the pull-

down menu to select Float 0.

The value will show as a floating-point

number with no decimal places.

22. Change the Entry Method field to None

using the pull-down menu.

No operator data entry is required for this

format.

23. Set the High Limit at 100000 by typing the

value in the High Limit field

This should correspond to the high limit

in the Totalizer block

24. In the Engineering Units field, type KLB. This represents “thousands of pounds”.

25. Close the dialog box using OK The format now appears on the formats

list.

26. Close the block using OK

Figure 2 .20.

Display Block

Formats - Totalizer

27. Connect the TC output of the TOT block

to Input 1 (I1, Total) of the Display block.

TC represents “Total Count” and will be

displayed on Line 2.

Figure 2 .21.

Block Connections

for displaying Total

TC TOTAL

28. Add the Display tag STM TOT to the

Display List in the Display Interface Block

as shown below.

You may also wish to use this as your

display to appear on power-up.

TOT DISP

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 97 98

Keine Kommentare

Micromod MOD: 30ML Display Script Guide Bedienungsanleitung Seite 31