Micromod MOD: 30ML Controller Operation and Maintenance Tra Bedienungsanleitung PDF herunterladen (Seite 42)

Training Manual

Single Loop Template Lab

3 - 20

3.3.10 SETPOINT Setup

1 Press DOWN to enter setpoint section.

2 Press NXT until SETPOINT HI LIMIT

is displayed on lines 1 and 2.

Setpoint values to the PID algorithm are limited

to this number or below

3 Set the high limit at 200. Then

press ENT.

4 Press NXT until INITIAL VALUE is

displayed.

5 Set the value at 100.0. Then press

ENT.

Setpoint value when configuration is complete.

6 Press NXT until lines 2 and 6 are blank

and only the up arrow is on.

COMPOUND will be displayed on Line 1

7 Press UP This completes the Setpoint section

8 Press NXT This takes you to the top of the Control section.

Line 2 will display CONTROL.

Figure 3 .20.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 73 74

Keine Kommentare

Micromod MOD: 30ML Controller Operation and Maintenance Tra Bedienungsanleitung Seite 42