Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Bedienungsanleitung PDF herunterladen (Seite 36)

3.2.4 CONFIGURE A DATAPOINT

The following procedure illustrates how to alter the contents of datapoint C115 (CONTROL module

& Span parameter) from 100 to 200.

3.2.4.1 Procedure to Configure a Datapoint

•

Press the

Mode

button to enter the ENGINEER

mode indicated by the appearance of either

CONFIG-

URE

DISPLAY

PROGRAM

at the bottom of the

display.

•

If CONFIGURE does not appear, press F2 until

CON-

FIGURE

appears at the bottom of the display.

•

When

CONFIGURE

is displayed at the bottom, press

F3.

•

If using the Hi-Res display, as shown, press F2 until

DATAPOINT

appears at the bottom of the display.

•

Then press F3 to enter

DATAPOINT

mode.

•

The screen should now show the point-entry line similar

to the one at the right.

•

Press the key until the character "C" appears on

the entry line.

•

Press the key to shift the first entry one position to

the left.

•

Press the key until "1" appears on the entry line.

•

Press the key to shift this entry one position to the

left.

•

Press the key until "1" appears on the entry line.

•

Press the key to shift this entry one position to the

left.

•

Press the key until "5" appears on the entry line.

•

The entry line should appear similar to that shown on

the right.

•

Press F3.

MODULAR CONTROLLER QUICK START

3-11

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 98 99

Kommentare zu diesen Handbüchern

Keine Kommentare

Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Bedienungsanleitung Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller