Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Bedienungsanleitung PDF herunterladen (Seite 87)

INSTALLATION DIAGRAMS

A copy of each of the following interconnection diagrams is included in this Appendix.

In Class I, Division 2 installations these drawings shall be used in place of the installation drawings

provided in the 53MC5000 Instruction Manual and 53MC5000 Quick Start Installation Guide.

ID-53-1592 Installation Diagram, Standard Rear Terminal Board and Expansion

Rear Terminal Board

ID-53-1593 Installation Diagram, Discrete ITB and Dual Relay ITB

ID-53-1594 Installation Diagram, Cord Set Rear Terminal Board and Expansion

Rear Terminal Board

ID-53-1595 Installation Diagram, Cord Set ITB and Dual Relay ITB

ID-53-1596 Installation Diagram, Analog ITB

ID-53-1597 Installation Diagram, MicroLink Communications

ID-53-1598 Installation Diagram, Standard Communications with Cord Set

ID-53-1599 Installation Diagram, Standard Communications with Standard Rear Ter-

minal Board

ID-53-1601 Installation Diagram, Controller to SCADA Adaptor

ID-53-1603 Installation Diagram, 16DI/DO ITB

CORRECTIVE MAINTENANCE

WARNING

EXPLOSION HAZARD, DO NOT DISCONNECT CABLES, MODULES, OR

FUSES UNLESS POWER HAS BEEN DISCONNECTED OR THE AREA IS

KNOWN TO BE NON-HAZARDOUS.

When the equipment is installed in a Class I, Division 2 location, no service that requires the removal,

replacement, or connection of components or wiring shall be performed on any circuits not known to

be operating at intrinsically safe energy levels unless the power supplies have been disconnected or

the area is known to be nonhazardous. If the area is to be declared nonhazardous, it is the user’s

responsibility to determine whether the atmosphere is hazardous with a suitable combustible gas

detector.

MODULAR CONTROLLER QUICK START

A-4

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 98 99

Keine Kommentare

Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Bedienungsanleitung Seite 87